Vertical Saber Stand Assembly Instructions

The vertical saber stand requires some assembly. Below you can find instructions on how to assemble it.

 

	The package should include: - base plate - front plaque holder - rear shelf - 2x long posts - 2x short posts - 8 screws - 4 brass collars - 4 aluminum covers
	Screw the two long posts to the base plate where the holes are closer to the edge. The screw heads should sit inside the indented holes.
	Screw the two short posts to the base plate where the holes are further from the edge. The screw heads should sit inside the indented holes
	Place the angled plate holder on top of the two short posts near the front of the base plate. Insert 1 brass collar per screw hole with the wider side facing up. Screw the plaque holder to the posts while keeping the brass collars centered.
	Place the back shelf on the long posts, with the cutout facing inwards. Insert 1 brass collar per screw hole with the wider side facing up. Screw the rear shelf to the posts while keeping the brass collars centered.
	Screw each of the aluminum caps using the threaded brass collars for the rear shelf and the front plaque holder.

Notes

• The threaded holes in each of the posts may not be perfectly straight. You can rotate the posts to adjust alignment of the rear shelf and front plaque holder